O'So Sticky Tape Tips:  Surface and all materials must be clean and dry. Tape and other material must be warm (at least 75 degrees) for best results. If colder, warm gently with a heat (embossing) gun or hair dryer.

Tape may damage some surfaces if removed.

Directions:

Apply tape to surface, remove liner, apply beads, glitter, embossing powder, flocking, Diamond Dust, etc. or use to bond two surfaces together.  Bonds instantly.  Cures overnight to an even stronger hold.

O'So Sticky Powder
 

O'So Sticky Powder is a heat activated glue powder that is used like embossing powder to make an image sticky - perfect for adding our Ultra Fine Micro Beads or other embellishments to your stamping projects! $ 3.50 each, 1 oz Jar

 

Micro Beaded Stamped Image

Close Up of Micro Beaded Image

Instructions for Heated Beads Technique:

1. Stamp an image with embossing ink, Versamark or your favorite colored pigment ink.

2. Sprinkle O’So Sticky Powder over the inked image and tap off excess.

3. Heat the image just until the powder turns to liquid - it will be shiny. Do not overheat.

4. Pour micro beads onto the melted powder to coat and tap off excess.

5. Heat again briefly to set the beads.

Note: Over time O’So Sticky Powder will absorb moisture from the air. Keep jar airtight for longest shelf life. If powder clumps, just dump out, break up clumps and return to jar.
 

SureTac All-Purpose Glue