Supply List:
Large Plain Sticker or Label
Rubber Stamp(s) and Ink Pad(s)
Bic Round Stick Pen (These instructions are specific to THIS pen!)
O'So Sticky Double Sided Tape Sheet
Clear Glass Micro Beads (no hole) .5 mm size

To estimate supplies needed: One 6"x8" Sheet of O'So Sticky can be cut to cover 8 pens, and one 5 oz bag of clear beads can cover 25-30 pens.

Click [HERE] for a box template for your pens.  Close the window to return to this page.

Check out the perfect addition to our  Stamped and Beaded Pen Tutorial - Our Post It Note Purses [HERE]

Directions:


 

Step 1:

Place Clear Micro Beads into a Tidy Tray or dish.  Remove the lid from the pen.

Step 2:

Stamp a design on the label and then cut to 4 and 1/4" by 1 and 1/32". This should be the exact size to wrap the label around the pen Lengthwise and not have an overlap.

Step 3:

Peel off the backing and wrap it as straight and as tight as you can around the pen placing it as close to the top edge (not pointed end) as possible.  This way you can still put the lid on it! A small overlap is okay.

Step 4:

Roll it on the table to ensure that it is stuck on good!

Step 6A:

Peel away one side of the protective liner.
 

Step 7A:

Peel away the other liner and then roll the pen into the beads by pressing firmly as you turn it making sure to fill all of the gaps and spaces. Try not to touch the tape!

Step 8:

Once coated with beads, roll the pen tightly between your palms to press them into the tape and brush away any loose beads. The heat from your hands will "seat" the beads into the tape so that they will stay attached with use of the pen!

You may need to repeat Steps 7 and 8 a couple of times to get complete coverage.

PLEASE RESPECT COPYRIGHT LAWS

While we DO encourage you to share the ideas you learn here, you are not
authorized to distribute this class in electronic, printed or written form
without written permission from the author.

© Suzanne Glazier of Penny Wise Art Supplies
 

Notes From Suzanne:  Making Adjustments To Fit Different Pen Sizes

These instructions are specifically tailored to fit a Bic Roundstick Pen.
If you want to use another brand, all you need to do is adjust the measurements to fit THAT pen!

The easiest way to accomplish this is to start with a piece of scrap paper with the BIC measurements of 4 and 1/4" by 1 and 1/32". Wrap this paper around the pen you wish to use and see where you need to adjust!

Be sure to add a little more to the width when you are cutting your tape - as the label adds just a smidge to the diameter of the pen and if you cut the label and tape the same size, the tape will fall short of making the full circumference!

Pens that are perfectly round and not tapered will ensure the best results!